Mitsubishi Electric FATEC FR-A800 Manual page 148

9
REPLACEMENT PROCEDURE
(7) Select [Read from connected inverter].
Check that [Connection type] is "USB",
and specify the station number connected
to the source inverter in [Target station].
After specifying the station number, click
[Detection]. After detection, check the
inverter model in the [Model] field, and
click [OK] to convert the parameters and
return to the "Convert" window.
(8) The setting value can be changed for
some parameters of the source. To
change the parameter setting value, enter
the desired value in the setting value field
of the source parameter list. After the
parameters of the source inverter are
displayed in the list, the [Convert...] button
in the "Convert" window will be active.
Click [Convert...] to display the "Convert"
window.
(9) Specify "Model/Capacity" of the [Target
inverter] in the "Convert" window. Click
[OK] to convert the parameters and return
to the "Convert" window.
(10) The result of parameter converting is
shown in the "Convert" window.
(11) Click [Reflect...] in the "Convert" window
to display the "Reflect" window. Select
[Save in file]. Specify the destination to
save the file and click [OK]. The converted
parameter setting is saved in the
parameter file (*.pr4).
[Converting without a personal computer]
If a personal computer cannot be prepared, the parameter setting values for FR-A800 series must be
created. The parameter numbers are almost the same as for FR-A700 series, but some of the setting
values differ. Refer to the parameter section in "Information for Replacement of FR-A700 Series
(BCN-C21002-162)" and create the parameter setting values for FR-A800 series.
9.1 Saving FR-A700 parameters and replacing with FR-A800 parameters
Select [Read from connected inverter]
Click [Detection].
Set the target inverter.
Click [Convert...].
Click [Reflect...].
Specify the destination
to save the file.
143
9