Awd / 2Wd / Turf Switch; Seat Belt Switch - Polaris RZR PRO R Service Manual

ELECTRICAL

AWD / 2WD / TURF SWITCH

PIN CONTINUITY
SWITCH POSITION
POS 1
ON
POS 2
OFF
POS 3
ON
SWITCH FUNCTION
PIN
1
2
3
4
5
6
7
8
1. Disconnect the AWD / 2WD / TURF switch harness
by depressing the connector locks and pulling on the
connector. Do not pull on the wiring.
2. Test between the 3 sets of outputs (AWD / 2WD /
TURF). If any of the tests fail, replace the switch
assembly.
3. Move the switch to AWD. There should be continuity
between switch pins 2 and 3.
4. Move the switch to 2WD. There should be no
continuity between any pins.
5. Move the switch to TURF. There should be continuity
between switch pins 1 and 2.
NOTICE
Pins 7 and 2 provide power and ground to light the
switch lamp.
12.14
CONTINUITY BETWEEN
Pins 2 and 3
—
Pins 1 and 2
FUNCTION
Turf Request Input
Ground, AWD Switch
AWD Request Input
—
—
—
Key Switch B+, AWD
Switch Light
—

SEAT BELT SWITCH

Location
Found on the driver's seat belt latch
Functionality
If the circuit is open (buckle undone) vehicle speed will
be limited to 15mph. If the circuit is closed (buckle
inserted), the vehicle will function normally.
Testing:
1. Disconnect the harness
2. Using a multi-meter, measure between both pins on
switch.
SEAT BELT
DISENGAGED
Between both
pins on switch
9940259 R02 - 2022 RZR PRO R / PRO R 4 Service Manual
q
running to the seat belt.
SEAT BELT
ENGAGED
∞ (OL)
< 1 Ω
© Copyright Polaris Industries Inc.