Driven Clutch Assembly - Polaris RZR PRO R Service Manual

PVT SYSTEM
6. Remove the bushing and bushing removal tool from
the puller. Discard the bushing.
HELIX BUSHING INSTALLATION
R
1. Apply Loctite 620 evenly to bushing bore in cover.
2. From the bottom of the Helix, insert the new bushing
w
and bushing adapter
3. Install the main adapter
securing nut on top of the Helix.
4. Use a pry bar located between the fingers of the Helix
to turn the Helix counterclockwise. Turn until bushing
bottoms out.
IMPORTANT
Only light force is needed to install the bushing. Do not
increase pressure after bushing bottoms out, or
damage may result to bushing.
5. Remove nut and spacer adapter from puller rod. Re-
move Helix and bushing adapter from puller rod.

DRIVEN CLUTCH ASSEMBLY

q
1. Re-install washer , roller
clip is fully seated and roller rotates freely.
6.24
(PN 5020636)
q
, spacer adapter, and
w e
, and e-clip Ensure e-
t
2. Install clutch spring
r
helix . Ensure the clutch spring is fully seated.
3. Re-install the retaining fasteners
i
sheave onto the helix
orientation.
IMPORTANT
Using previous hole orientation will ensure the driven
clutch maintains balance.
4. Using clutch compressor PU-50518 compress the
driven clutch assembly.
The helix cover is loaded by the spring. Not using a
proper compressor may result in personal injury or
damage to the clutch.
9940259 R02 - 2022 RZR PRO R / PRO R 4 Service Manual
y
and clutch spring cap
u
and movable
o
using previous hole
CAUTION
© Copyright Polaris Industries Inc.
on the