speed is automatically fixed without any possible oscillation.
•
When the unit is restarted by the controller, the temperature automatically changes to the
(7)
setting temperature of "F5" or "F6".
•
Applicable to the fan, cooling and dry operation modes.
(8)
•
Applicable to the heating operation mode.
(9)
•
When the unit is restarted by the controller, the temperature automatically changes to the
(10)
setting temperature of "F5" or "F6".
•
Available only for 4-Way Cassette Type, 4-Way Cassette Compact Type, 2-Way Cassette Type,
(11)
1-Way Cassette Type, Ceiling Type.
•
Setting "P4" to "01", then the temperature of selected thermistor (sensor) can be shown.
(12)
•
Setting "01" can show sensor temperature selected in "P3".
(13)
NOTE
• On modifying the "
CF
the automatic louver to make a full cycle in automatic mode to apply the optional setting.
• The changes to the optional function settings must be done after 3 minutes have passed after
startup.
• It is recommended to keep track of the changes made to optional function settings, for further
reference.
• The optional settings are different according to the indoor and outdoor unit models. Check to
ensure that the unit has the optional setting or not.
• The optional functions with "X" mark at the individual setting column can change the condition
only when "All Rooms" is set.
8.2.1 Input / Output Setting
1 Press " " and " " simultaneously for 3 seconds to display input/output setting screen.
✓ If only one indoor unit is connected with the wired remote controller, step4 is displayed.
✓ If multiple indoor units are connected with the wired remote controller, step2 is displayed.
2 Indoor unit selecting screen is displayed.
✓ Each indoor unit has its own index number. And the corresponding refrigerant system
number and address number are displayed on the upper right corner of the screen.
PMEN0630 rev.0 - 07/2022
" (air outlet louver angle change) setting, restore the power supply or allow
8
47