Flow Of The Auto Configuration Operation - Mitsubishi Electric MELSEC iQ-R Series User Manual

Flow of the auto configuration operation

This section describes the flow of the operation when the auto configuration is used for setting parameters.
'I/O communication request' (Y11)
'I/O communicating' (X01)
'Request for saving/clearing
parameters to Flash ROM' (Y17)
'Auto configuration request' (Y15)
'Auto configuration executing' (X14)
'Auto configuration completion'
(X15)
'Auto configuration operation setting'
(Un\G1008)
'Master function parameters'
(Un\G468 to Un\G975)
(1) MOV/TO instruction
(2) Slave node (node address 1)
(3) Slave node (node address 2)
(4) Slave node (node address 3)
 Set the type and maximum detection node address to 'Auto configuration operation setting' (Un\G1008). Set "0004H" when the type of the auto configuration
is the all configuration and the maximum detection node address is 4.
 Turn off 'I/O communication request' (Y11) and 'Request for saving/clearing parameters to Flash ROM' (Y17).
 Turn on 'Auto configuration request' (Y15).
 The auto configuration starts and 'Auto configuration executing' (X14) turns on. The auto configuration takes approximately 60 seconds at maximum to
complete.
 When the auto configuration completes, 'Auto configuration completion' (X15) turns on.
 The parameter detail in each slave node is read and stored in 'Master function parameters' (Un\G468 to Un\G975). The setting of the detected slave nodes
is stored in order of the node address.
 When 'Auto configuration request' (Y15) is turned off, 'Auto configuration executing' (X14) and 'Auto configuration completion' (X15) turn off.
 Check 'Master function parameters' (Un\G468 to Un\G975). Check that the setting details, such as the node address, connection type, and number of I/O
points, are correct. Correct the item if it is incorrect.
1 FUNCTIONS
34
1.4 Auto Configuration Function
ON
Ó
OFF
ON
OFF
OFF Ó
Ô
OFF
OFF
OFF
Ò
(1)
(2)
(3)
(4)
Ø
ON
Õ
ON
Ö
ON
×
ON
ON
OFF
OFF
OFF
Ù
(1)