Advertisement
3. Remove the dipstick (A).
4. Clean the oil from the dipstick.
5. Put the dipstick back in and tighten it.
6. Remove the dipstick again and read the oil level.
The oil level is correct when it is between the "Max."
and "Min." marks on the dipstick.
MAX
MIN
7. If the oil level is low, fill the oil through the hole for
the dipstick. Fill the oil slowly. Refer to
data on page 107 .
8. Do a check of the oil level again.
1401 - 002 - 15.10.2021
To do a check of the oil level in the
drive motor
A
1. Start the product. Refer to
2. Operate the caterpillar tracks until 1 of the plugs is
3. Park the product on level ground and stop the
4. Clean the area around the plugs to prevent
5. Remove the level plug (A).
6. Look in the level plug hole (B). The oil level is correct
Technical
145) on page 52 and To start the product (DXR 275,
DXR 305, DXR 315) on page 53 .
level with the center of the hub. The other plug is in
the top position.
To stop the product (DXR 145) on
product. Refer to
page 62 and To stop the product (DXR 275, DXR
305, DXR 315) on page 62 .
contamination of the drive motor system.
when the oil is at the edge of the level plug hole.
To start the product (DXR
B
A
77
Advertisement
