Advertisement
To install and remove the caterpillar
track wideners (DXR 275, DXR 305,
DXR 315)
The caterpillar track wideners make the product more
stable.
1. Start the product. Refer to
275, DXR 305, DXR 315) on page 53 .
2. Put the product on a stable surface.
3. Extend the outriggers. Refer to
outriggers on page 61 .
4. Stop the product. Refer to
275, DXR 305, DXR 315) on page 62 .
5. Do the procedure that follows on each caterpillar
track.
a) Loosen the 4 screws (A) and (B) for the
caterpillar track widener.
D
b) Push the plate (C) to the side.
c) Pull the caterpillar track (D) out until it stops.
d) Make sure that the distance between the
caterpillar track and product is sufficient for the
caterpillar track widener. If it is necessary, loosen
the 2 screws (B) some more. Pull the caterpillar
track (D) out until it stops.
1401 - 002 - 15.10.2021
To start the product (DXR
To operate the
To stop the product (DXR
A
B
C
e) Install the caterpillar track widener. The holes on
the caterpillar track widener must point at the
product.
f) Push the caterpillar track (E) against the product.
g) Tighten the 2 M10 screws (F) and the 2 M24
screws (G) for the caterpillar track widener.
Torque the M10 screws to 47 Nm and the M24
screws to 500 Nm.
6. Remove the caterpillar track wideners in the
opposite sequence.
To install and remove the tools on the
product
If a tool is not installed on the product, the hoses on the
tool must always be connected together.
E
F
G
31
Advertisement
