Advertisement
CAUTION:
pressure washer on the remote control.
To clean the batteries and the battery charger
CAUTION:
the battery charger with water.
•
Make sure that the batteries and the battery charger
are clean and dry before you connect the batteries to
the battery charger.
•
Clean the terminals on the batteries with
compressed air or a soft and dry cloth.
•
Clean the surfaces of the batteries and the battery
charger with a soft and dry cloth.
To do after you clean the product
•
Lubricate all lubrication points on the product. Refer
To lubricate the product (DXR 145) on page 80
to
To lubricate the product (DXR 275, DXR 305,
and
DXR 315) on page 81 .
•
If you have cleaned the product with water, let the
product become fully dry before you start the
product.
CAUTION:
start the product after it has been
cleaned with water. Components that are
damaged because of moisture can have
an unwanted effect on the movements of
the product.
To release the hydraulic pressure in the
hydraulic system (DXR 145)
1. Start the product. Refer to
145) on page 52 .
2. Extend the arm system until the arm system touches
the ground with minimum pressure. The hydraulic
pressure in the hydraulic cylinders is released.
3. Extend the outriggers until the outriggers touches the
ground with minimum pressure. The hydraulic
pressure in the hydraulic cylinders is released. Refer
To operate the outriggers on page 61 .
to
4. Stop the product. Refer to
145) on page 62 .
1401 - 002 - 15.10.2021
Do not use a high-
Do not clean the batteries or
Be careful when you
To start the product (DXR
To stop the product (DXR
5. Remove the 4 screws and the front cover.
6. Clean the area around the air filter.
7. Remove the air filter to release the hydraulic
pressure in the hydraulic oil tank.
8. Wait 5 minutes for the hydraulic pressure to
decrease through internal leakage.
9. Install the air filter on the hydraulic oil tank.
10. Install the front cover and tighten the 4 screws.
For the caterpillar track unit, release the hydraulic
pressure in the hydraulic accumulator. Refer to
remove and install the caterpillar tracks (DXR 145) on
page 85 .
To
67
Advertisement
