Toro 02710 Operator's Manual page 7

Adjusting the Axle Height
Adjust the axle position to the selected height-of-cut
setting. Refer to Height-of-Cut Chart (page
1. Park the machine on a level surface, disengage
the PTO, and engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Place a jack under the engine frame. Raise the
back end of the engine frame enough to remove
the drive wheels.
4. Remove the drive wheels.
5. Loosen, but do not remove, the 2 top axle bolts
(Figure 4).
6. Remove the 2 lower axle bolts
1. Top axle bolt
7. Raise or lower the mounting bracket, so that
you can install the 2 axle adjustment bolts in the
desired hole location
Note:
A tapered punch can be used to help
align the holes.
8. Tighten all 4 bolts.
9. Install the drive wheels and lower the machine.
8).
(Figure 4).
Figure 4
2. Lower axle bolt
(Figure 4).
Adjusting the Caster Position
1. Using the
the caster spacers to match with the axle hole
selected (Figure
1. Latch pin
2. Spacer (5 mm or 3/16 inch)
2. Remove the latch pin, slide the caster from the
support, and change the spacers
3. Install the caster in the support and insert the
latch pin
g001512
7
Height-of-Cut Chart (page
5).
Figure 5
3. Spacer (13 mm or 1/2 inch)
(Figure 5).
8), adjust
g001456
(Figure 5).