Toro 02710 Operator's Manual page 13

1. Assist arm
2. Front assist arm stop
3. Rear assist arm stop
4. Turnbuckle
8. To adjust the assist arm link, remove the hairpin
cotter from the assist arm
9. Loosen the nut against the yoke
10. Remove the assist arm link from the assist arm
and rotate the link to adjust the length.
11. Install the assist arm link into the assist arm and
secure it with the hairpin cotter
12. Check if the assist arm hits against the stops
correctly.
Adjusting the PTO Safety Switch
1. Park the machine on a level surface, disengage
the PTO, and engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Disengage the PTO. Make sure that the assist
arm is against the front assist stop arm.
4. If needed, adjust the blade safety switch by
loosening the bolts holding the switch bracket
(Figure 13).
5. Move the mounting bracket until the bellcrank
presses the plunger by 6 mm (1/4 inch).
Make sure that the bellcrank does not touch
the switch body or damage to the switch could
occur (Figure 13).
6. Tighten the switch mounting bracket.
Figure 12
5. Assist arm link
6. Yoke
7. Hairpin cotter
(Figure 12).
(Figure
(Figure
g001849
1. Bellcrank
2. Bolts and nuts
11).
12).
13
Figure 13
3. Switch mounting bracket
4. Switch body
g001855