Table of Contents
Advertisement
Hybrid cable mounting clamp and installation standards
When fixing hybrid cable to the tower ladder, use the clamp of photo below and fix
use of a clamp, and fix cable with fixed-interval of once per 3feet.
2.7.2 Connecting DU Cabinet side cable
If the length of the hybrid cable is inadequate for the installation:
1) Measure the hybrid cable's excess length.
(With a white marker pen, mark the area of the cable where the double-layer sheath
will be peeled when positioned in the conduit fitting.)
2) Using a knife, peel off the heat shrink tube that binds the cables together.
3) Pull the peeling wire in the inside of the hybrid cable's double-layer sheath down to
the previously marked area.
4) Peel off the hybrid cable's sheath.
5) Peel off the aluminum foil wrapped around the inner cable.
6) For all power cables, leave 1000 mm from where the double-layer sheath has been
peeled off and cut the excess length off.
7) Unsheathe the end of the power cable wire at 15 mm.
8) Using a conduit, insert the hybrid cable's power cable and optic cable together into the
cabinet. Be careful not to damage the optic cable's connector.
© SAMSUNG Electronics Co., Ltd.
Hybrid Cable
Ladder
Clamp
Smart MBS RRH-P4 Installation Manual/Ver.2.0
2-23
Advertisement
Table of Contents
