Figure 2.8 Connecting Rrh-C2A Feeder Line (1) - Samsung Smart MBS RRH-C2A Installation Manual

1) Install 1/2 inch feeders line from the RF port at the bottom of RRH-C2A to the RF
antenna.
2) Insert a heat shrink tube (jelly type) to each end of the installed 1/2 inch feeder lines,
then connect a din-male connectors to the RRH-C2A's RF port and the RF antenna
port.
3) After installing the connector, shrink the heat shrink tubes using a heat gun.
© SAMSUNG Electronics Co., Ltd.

Figure 2.8 Connecting RRH-C2A Feeder Line (1)

Smart MBS RRH-P4 Installation Manual/Ver.2.0
Din-Type Male Connector
1/2 in. Feeder Line
Heat Shrink Tube (Jelly Type)
Detail 'A'
2-11