Table of Contents
Advertisement
5.
Remove the hand knobs from the lower
handlebar assembly and rotate the assembly
away from the engine.
Figure 6
6.
For each side shield, align the shield grooves
with the center tine shield, slide the side shield
onto the center tine shield, and push it until you
hear/feel it click into place. Ensure that the
shield is secure.
Figure 7
7.
Rotate the lower handlebar assembly toward
the engine to the desired position and install
the hand knobs through the mount holes and
tighten them.
Figure 8
2
Installing the Handlebars
Parts needed for this procedure:
4
Bolt (M8 x 40 mm)
4
Bolt (M6 x 40 mm)
4
Washer
4
Locknut (M8)
g358170
4
Locknut (M6)
1
Left handlebar
1
Middle dash panel
1
Right handlebar
Procedure
1.
Align the 2 right handlebar mount holes with
the lower handlebar mount holes at the desired
height and secure it as shown. Repeat for the
left handlebar.
g358168
1. Right handlebar
2. Left handlebar
3. Bolt—M8 x 40 mm (2)
g358169
8
Figure 9
4. Washer
5. Nut—M8 (2)
g358243
Advertisement
Table of Contents
