Setup; Installing The Rear Wheels - Toro 09802 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
Media and Additional Parts
Description
Ignition Key
Hose Adapter
Spanner Wrench
Operator's Manual
Parts Catalog
1

Installing the Rear Wheels

Parts needed for this procedure:
3 Wheel
12 Lug nut
Procedure
1. Remove the wheels from the shipping pallet.
2. Mount the wheels to the hubs with the lug nuts
(supplied in loose parts) (Figure 2) and torque the
nuts to 45-55 ft./lb. (61-75 N-m).
Description
Wheel
Lug nut
Bulk electrolyte, not supplied
No parts required
Qty.
3
12
A/R
–
Qty.
1 Use in ignition switch.
1 Mount to quick coupler on side of machine.
1 Use for installation and removal of water filter.
1 Read before operating the aerator
1 Use to reference part numbers.
1. Wheel
3. Remove any shipping blocks or braces, which may
obstruct machine removal from the pallet.
9
Use
Install the rear wheels
Activate and charge the battery.
Check the tire pressure.
Use
Figure 2
2. Lug nuts