Table of Contents
Advertisement
Chapter 3 How to Use the Printer Driver
Note
• The Stop position (or Cutting position) can be set in increments of 0.5 mm (0.02 inch)
between -10.0 (-0.39 inch) and +10.0 mm (+0.39 inch).
• To reset the Stop position (or Cutting position) settings to the defaults, click [Defaults].
5
Click [Send].
A confirmation message appears.
6
Click [Yes].
The setting is transmitted to the printer.
7
Perform test printing.
Check that the paper has been cut in the middle between two sheets of paper, and then start
an actual print job.
104
Advertisement
Table of Contents
Troubleshooting
