Panasonic Aquarea WH-ADC0309J3E5 Planning And Installation Manual page 215

Menus
Menu
6.3
*
1,
Automatic switch from Heat to
Cool or Cool to Heat�
6.4
Tank
Setting functions for the tank�
* The system is locked to operate without COOL mode� It can be unlocked only by authorised installers or our authorised service partners�
1
* Only displayed when COOL mode is unlocked (This means when COOL mode is available)�
2
32
Aquarea air-to-water heat pumps - Planning and installation manual - 02/2022
For installer
Default Setting
Water temp. for cooling ON Direct
10 °C
• If 2 zone system is selected, temperature set point must input for Zone 2�
• "Zone 1" and "Zone 2" will not appear on the display if only 1 zone system�
T for cooling ON
5 °C
* Auto
2
Outdoor temperatures for switching from Heat
Outdoor temp� for (Heat to Cool) /
Outdoor temp� for (Cool to Heat)
Outdoor temp. for (Heat to Cool)
15 °C
Outdoor temp. for (Cool to Heat)
10 °C
Floor operation time (max) /
• The display will show 3 functions at a time�
Floor operation time (max)
8:00
Setting Options / Display
Set temperature for
Cooling ON
Set T for cooling ON
* This setting will not
available to set when
pump flowrate set to
Max� duty�
to Cool or Cool to Heat�
Set outdoor
temperature for
switching
from Heat to Cool�
Set outdoor
temperature for
switching
from Cool to Heat�
Tank heat up time (max) /
Tank re-heat temp� /
Sterilization
Maximum time for
floor operation
(in hours and minutes)
Appendix
8
215