Advertisement
3-6. REMOVAL OF PW1 BOARD, CAMERA BLOCK
ASSEMBLY AND STAND ASSEMBLY
1 . Disconnect the connector CD and the two screws ® , and
then remove the PW1 board ® .
2. Remove the three screws @ , and then while pushing the
hooks @ , remove the camera block assembly ® from the
VTR block assembly (]) .
@ PW1 board
@ Hooks
3. Remove the two screws
assembly ® .
When carrying out the steps i n
•
remove the camera block assembly ® but
JUSTMENT,"
not the PW1 board ® .
® Stand assembly
- 3-6 -
®
and then remove the stand
,
"5. ELECTRICAL AD
i
@ Screws 1 .7
x 6
(# 1 04)
@ Screws 1 .7 x 4
(#1 00)
Advertisement
