Pre-Maintenance Procedures; Using The Cylinder Locks - Toro TX 1300 Operator's Manual

Pre-Maintenance
Procedures

Using the Cylinder Locks

WARNING
The loader arms may lower when in the raised
position, crushing anyone under them.
Install the cylinder lock(s) before performing
maintenance that requires raised loader arms.
Installing the Cylinder Locks
1. Remove the attachment.
2. Raise the loader arms to the fully raised position.
3. Shut off the engine and remove the key.
4. Loosen the knob securing the cylinder lock to
the loader arm.
Figure 57
1. Pin
2. Cylinder lock
g359013
3. Hand knob
5. Slide the cylinder lock over the lift-cylinder rod.
1. Cylinder lock
2. Lift-cylinder rod
6. Repeat step 4
machine.
7. Slowly lower the loader arms until the cylinder
locks contact the cylinder bodies and rod ends.
8. Secure the loader-valve lock; refer to
Loader-Valve Lock (page
42
Figure 58
3. Pin (2)
and 5 for the other side of the
14).
g267536