Toro TX 1300 Operator's Manual page 58

7. Loosen the jam nut and turn the tensioning
screw to release the tension.
1. Tensioning screw
8. Remove the segment of the drive sprocket not
engaged with the track.
Important:
If you do not remove the
sprocket segment, it may be difficult to
install a new track without damaging it.
1. Bolt (5)
9. Start the machine and disengage the parking
brake.
10. Move the traction control forward until the other
half of the drive sprocket is not engaged with
the track
11. Shut off the engine and remove the key.
Figure 89
2. Jam nut
Figure 90
2. Sprocket half
Figure 91
12. Remove the track from the track frame, drive
hub, then front wheel.
Installing the Tracks
1. Wrap the new track around the front wheel.
g363401
1. Track
2. Front wheel
2. Push the track under and between the road
wheels and wrap it around the rear wheel.
3. Start the engine and disengage the parking
brake.
4. Move the traction control forward until the drive
sprocket half engages with the track.
g361327
5. Shut off the engine and remove the key.
g361325
58
Figure 92
3. Road wheel (4)
4. Rear wheel
Figure 93
g361328
g361324