Tool Air Piping - Toshiba THL Series Instruction Manual

16.2 Tool Air Piping

The customer is requested to install the tool air piping using the following accessories.

Air tube x3 (red, white, blue)
Fig. 16.2 shows an installation example of tool air piping for your reference.
Make holes on the metal
plate cover, and fasten
the air tubes with bolts
and nuts.
(To be prepared by the
customer)
Fig. 16.2 Tool air piping wiring example (THL300 and THL400)
• Air tubes are consumable supplies. Check the air tubes during periodic inspection, and
change them if any damage is found.
• The customer is requested to prepare solenoid valve air.
• Please be aware that Fig. 16.2 shows a piping example, and it does not guarantee the air
tubes and their accessories to be free from damage.
TRANSPORTATION AND INSTALLATION MANUAL
3 x 4 air tube
One-touch joint
for 3 x 4 hand
!
CAUTION
172
Cable tie
STE 85356