Drive System Maintenance; Maintaining The Tires - Toro Workman GTX Operator's Manual

Adjusting the Headlights
Use the following procedure to adjust the headlight
beam position whenever a headlight assembly is
replaced or removed.
1. Park the machine on a level surface with the
headlights approximately 7.6 m (25 ft) from a
wall (Figure 44).
2. Measure the distance from the floor to the center
of the headlight and make a mark on the wall at
the same height.
3. Turn the key switch to the O
on the headlights.
4. Take note of where the headlights aim on the
wall.
The brightest part of the headlight beam should
be 20 cm (8 inches) below the mark placed on
the wall (Figure 44).
Figure 44
5. At the back of the headlight assembly, rotate
adjustment screws
headlight assembly and align the position of the
cast beam.
6. Connect the batteries and close the hood; refer
to Connecting the Batteries (page
position, and turn
N
(Figure 43) to pivot the
39).
Drive System
Maintenance

Maintaining the Tires

Service Interval: Every 100 hours—Check the
Every 100 hours—Torque the wheel-lug nuts.
1. Inspect the tires and rims for signs of wear and
damage.
Note:
Operating accidents, such as hitting
curbs, can damage a tire or rim and also disrupt
wheel alignment, so inspect tire condition after
an accident.
2. Torque the wheel lug nuts to 108 to 122 N∙m (80
to 90 ft-lb).
g298100
41
condition of the tires and rims.