Maintenance; Maintenance Safety; Recommended Maintenance Schedule(S) - Toro Workman GTX Operator's Manual

Maintenance

Note:
The procedures in this section show a
machine with a plastic cargo bed and bucket seat;
for additional procedures for other attachments, refer
to the Maintenance section (if applicable) in the
Installation Instructions. Visit www.Toro.com for your
instructions or scan the QR code (if applicable) on
your attachment.

Maintenance Safety

•
Do not allow untrained personnel to service the
machine.
•
Before you leave the operating position, do the
following:
– Park the machine on a level surface.
– Shift the transmission to the N
– Engage the parking brake.
– Lower the cargo bed.
– Shut off the machine and remove the key.
– Wait for all movement to stop.
•
Allow the machine to cool before adjusting,
servicing, cleaning, or storing it.
•
Support the machine with jack stands whenever
you work under the machine.
•
Do not work under a raised bed without the proper
bed safety support in place.
•
Do not charge the batteries while servicing the
machine.
•
To ensure that the entire machine is in good
condition, keep all hardware properly tightened.

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first 5 hours
After the first 8 hours
After the first 50 hours
After the first 100 hours
Before each use or daily
position.
EUTRAL
Maintenance Procedure
• Change the engine oil.
• Check the condition of the drive belt.
• Check the tension of the starter-generator belt.
• Check the air filter for the carbon canister.
• Perform the guidelines for breaking in a new machine.
• Inspect the seat belt(s) for wear, cuts, and other damage. Replace the seat belt(s) if
any component does not operate properly.
• Check the tire pressure.
• Check the engine-oil level.
• Check gear-shift operation.
• Check the brake-fluid level.
• Wash the machine.
•
To reduce the potential fire hazard, keep the
machine area free of excessive grease, grass,
leaves, and accumulation of dirt.
•
If possible, do not perform maintenance while the
machine is running. Keep away from moving parts.
•
If you must run the machine to perform a
maintenance adjustment, keep your hands, feet,
clothing, and any parts of the body away from
any moving parts. Keep bystanders away from
the machine.
•
Clean up oil and fuel spills.
•
Check the parking brake operation as
recommended in the maintenance schedule and
adjust and service it as required.
•
Keep all parts of the machine in good working
condition and all the hardware properly tightened.
Replace all worn or damaged decals.
•
Never interfere with the intended function of a
safety device or reduce the protection provided
by a safety device.
•
Do not overspeed the engine by changing the
governor settings. To ensure safety and accuracy,
have an Authorized Service Dealer check the
maximum engine speed with a tachometer.
•
If major repairs are ever necessary or assistance
is required, contact an authorized Toro distributor.
•
Altering this machine in any manner may affect the
operation of the machine, performance, durability,
or its use may result in injury or death. Such use
could void the product warranty of The Toro®
Company.
26