NEC Express5800 Series Maintenance Manual page 218

Chapter 3 Appendix
Error
Class
code
System Revision 3
System Revision 4
System Revision 7
System Revision 8
Maintenance 1
Maintenance 2
Power Cap 1
Power Cap 3
Power Cap 4
Flash Media 1
Flash Media 2
Flash Media 3
Flash Media 4
Flash Media 5
Interlock
218
Error message
#ILO detected invalid %1 firmware.
#ILO was unable to automatically repair
the %1 firmware.
#ILO completed the firmware integrity scan
and detected an anomaly.
Firmware recovery is requested by %1
IML Cleared (%1 user: %2)
Maintenance note: %1
Processor(s) Operating at Reduced
Performance Level Due to a Low Power Cap
Power Cap Cannot Be Reached With
Current System Configuration (Power
Cap %1W)
Power allocation not optimized. Increased
power allocation requested. Server
performance is not degraded
Boot From Flash Error (%1)
A read error occurred on the Flash Media in
Slot %1 of a USB storage device attached to
the system
A write error occurred on the Flash Media in
Slot %1 of a USB storage device attached to
the system
Redundancy is lost on a USB storage device
attached to the system. Flash Media in
Slot %1 has failed
Sync operation to restore redundancy failed
on a USB storage device attached to the
system
Improperly seated or missing device
1
(%1, %2)
Express5800/R120h-1E, R120h-2E Maintenance Guide
Action
If the record continues, contact your
maintenance service company.
Update the server platform service firmware. If
the problem persists, contact your sales
representative.
Action is not necessary.
Action is not necessary.
Action is not necessary.
Action is not necessary.
Contact your sales representative.
Contact your sales representative.
Contact your sales representative.
Connect the USB memory device again.
Contact your sales representative.
Contact your sales representative.
Contact your sales representative.
Contact your sales representative.
Contact your sales representative.
1. IML Error Message