NEC Express5800 Series Maintenance Manual page 187

Chapter 3 Appendix
Error
Class
code
UEFI 282
UEFI 284
UEFI 286
UEFI 287
UEFI 288
UEFI 289
UEFI 291
UEFI 292
UEFI 297
UEFI 311
UEFI 312
UEFI 315
UEFI 319
Error message
Invalid Server Serial Number and Product
ID - The Serial Number and/or Product ID
have been corrupted or lost.
DIMM Failure - Uncorrectable Memory
Error - Processor %1 Dimm %2
IMPORTANT: The removal of a storage
device has been detected. The device has
been removed from the Boot Controller
Order.
IMPORTANT: The removal of a network
device has been detected. The device has
been removed from the Standard Boot
Order (IPL)
IMPORTANT: A new storage device has
been detected and has been added to the
end of the Boot Controller Order.
A new network or storage device has been
detected. This device will not be shown in
the Legacy BIOS Boot Order options in
RBSU until the system has booted once.
IMPORTANT: The Standard Boot Order
(IPL) has been detected as corrupted and
has been restored to default values.
Invalid %1 Software RAID
Configuration. %2 SW RAID Mode is NOT
supported when the Boot Mode is
configured for legacy BIOS Mode.
IMPORTANT: iLO Security is disabled by
the associated switch being set to the ON
position. Platform security is DISABLED.
%1 Configuration Error - The system has
exceeded the installed battery capacity.
%1 %2 Failure - Communication with the
battery failed. Its output may not be
enabled.
An uncorrectable memory error was
detected prior to this system boot.
An Unexpected Shutdown was detected
prior to this boot.
Express5800/R120h-1E, R120h-2E Maintenance Guide
Action
The serial number and product ID for identifying the unit
are not correctly set. Contact your maintenance service
company.
Contact your sales representative.
Action is not necessary.
Action is not necessary.
Action is not necessary.
Action is not necessary.
Action is not necessary.
When using the corresponding Software RAID, the boot
mode must be changed to the UEFI mode. If the
problem persists, contact your sales representative.
The maintenance switch SW1 should be set to OFF
unless the setting is specified in the operating
procedure etc.
When operating the maintenance switch, follow the
procedure in Chapter 1 (7. Resetting and Clearing the
Server) in this manual.
If the problem persists, contact your sales
representative.
Add more batteries for the capacity increase, or reduce
the number of devices that need battery backup. If the
problem persists, contact your sales representative.
Make sure that the battery is correctly installed. If the
problem persists, contact your sales representative.
Contact your sales representative.
Action is not necessary.
1. IML Error Message
187