NEC Express5800 Series Maintenance Manual page 208

Chapter 3 Appendix
Error
Class
code
UEFI 259
UEFI 264
UEFI 265
UEFI 270
UEFI 275
UEFI 298
UEFI 299
UEFI 318
UEFI 330
UEFI 347
UEFI 347
208
Error message
Unsupported Processor Configuration
Detected. All installed processors do not
have the same model number.
Server Platform Services Firmware in
Recovery Mode. SPS Firmware Update
Switch 12 of the Maintenance Switch is in
the ON position.
System Configuration Error. The system
configuration has exceeded the
non-volatile storage capacity of the server
and certain settings may be lost.
%1 FW Communication Issue - Unable to
communicate with %2 FW. Certain
management functionality is not available.
Unsupported Processor Detected -
Processor stepping not supported.
IMPORTANT: The Boot Mode has been
changed to Legacy Boot Mode for this boot
only. On the next reboot, the Boot Mode
will return to UEFI Boot Mode.
The Boot Mode has been changed to UEFI
Boot Mode for this boot only. On the next
reboot, the Boot Mode will return to Legacy
Boot Mode.
Trusted Platform Module (TPM) Self-Test
Error.
Unsupported Processor Configuration
Detected - Processors are installed in the
incorrect order.
NVDIMM Population Error - %1 NVDIMMs
are present %2. Only %3 NVDIMMs are
supported.
NVDIMM Population Error - %1 NVDIMMs
are present %2. Only %3 NVDIMMs are
supported.
Express5800/R120h-1E, R120h-2E Maintenance Guide
Action
Make sure the processor is properly installed. If the
problem persists, contact your sales representative.
Set the maintenance switch SW12 to OFF unless the
setting is specified in the operating procedure etc.
When operating the maintenance switch, follow the
procedure in Chapter 1 (7. Resetting and Clearing the
Server) in this manual.
If the problem persists, contact your sales
representative.
Set the required settings again using the System Utility
after restoring factory default settings by selecting
System Configuration > BIOS/Platform
Configuration (RBSU) > System Default Options -
Restore Default Manufacturing Settings options from
the menu of the System Utility. If the problem persists,
contact your sales representative.
Turn off the power of this device, pull off the power code
and after 30 minutes, reboot the device.
In case a problem is not resolved, contact your sales
representative.
Contact your sales representative.
Action is not necessary.
Action is not necessary.
Turn off the unit, disconnect the power cord, wait 30
seconds, and then restart it. If the problem persists,
contact your sales representative.
Make sure the processor is properly installed. If the
problem persists, contact your sales representative.
Confirm the installation of NVDIMM. In case a problem
is not resolved, contact your sales representative.
Make sure the NVDIMM is properly installed. If the
problem persists, contact your sales representative.
1. IML Error Message