Table of Contents
Advertisement
Figure 32
1. Transport latch (side cutting units)
Operating Tips
Mow When Grass is Dry
Mow either in the late morning to avoid the dew, which causes
grass clumping, or in late afternoon to avoid the damage
that can be caused by direct sunlight on the sensitive, freshly
mowed grass.
Select the Proper Height-of-Cut Setting
to Suit Conditions
Remove approximately 25 mm (1 inch) or no more than 1/3
of the grass blade when cutting. In exceptionally lush and
dense grass, you may have to raise the height-of-cut to the
next setting.
Mow at Proper Intervals
Under most normal conditions you will need to mow
approximately every 4-5 days. But remember, grass grows at
different rates at different times. This means that in order to
maintain the same height-of-cut, which is a good practice,
you will need to cut more frequently in early spring; as the
grass growth rate slows in mid summer, cut only every 8-10
days. If you are unable to mow for an extended period due
to weather conditions or other reasons, mow first with the
height-of-cut at a high level; then mow again 2-3 days later
with a lower height setting.
Transporting
Use the transport latches when transporting over long
distances, rough terrain, or when trailering.
After Operating
To ensure optimum performance, clean the underside of the
mower housing after each use. If residue is allowed to build
up in the mower housing, cutting performance will decrease.
Also, remove any debris which may have collected between
the deck lift cylinders and the foam deck pads
1. Deck lift cylinder
Cutting Unit Pitch
A blade pitch of 8 to 11 mm (5/16 to 7/16 inch) is
recommended. A pitch larger than 8 to 11 mm (5/16 to 7/16
inch) will result in less power required, larger clippings, and
a poorer quality of cut. A pitch less than 8 to 11 mm (5/16
to 7/16 inch) will result in more power required, smaller
clippings and a better quality of cut.
35
(Figure
Figure 33
2. Foam deck pad
33).
Advertisement
Table of Contents
