Servicing The Engine Oil And Filter - Toro 30604 Operator's Manual

Figure 47
1. Air cleaner primary filter
Figure 48
1. Air cleaner safety filter
Important: Never attempt to clean the safety filter
(Figure 48). Replace the safety filter with a new
one after every three primary filter services.
4. Replace the primary filter
5. Insert the new filter by applying pressure to the outer
rim of the element to seat it in the canister. Do not
apply pressure to the flexible center of the filter.
6. Clean the dirt ejection port located in the removable
cover. Remove the rubber outlet valve from the cover,
clean the cavity and replace the outlet valve.
7. Install the cover orienting the rubber outlet valve
(Figure 46) in a downward position - between
approximately 5:00 to 7:00 when viewed from the end.
Secure the latch.
(Figure 47).
Servicing the Engine Oil and
Filter
Service Interval: Every 250 hours
Change the oil and filter every 250 hours.
1. Remove the drain plug
into a drain pan. When all the oil is drained, install
the drain plug.
1. Engine oil drain plug
2. Remove the oil filter
clean oil to the new filter seal before screwing it on.
Do not overtighten.
1. Engine oil filter
3. Add oil to the crankcase; refer to Checking the Engine
Oil.
41
(Figure 49) and let the oil flow
Figure 49
(Figure 50). Apply a light coat of
Figure 50