Lubrication; Greasing The Bearings And Bushings - Toro 30604 Operator's Manual

Lubrication

Greasing the Bearings and
Bushings
The machine has grease fittings that must be lubricated
regularly with No. 2 general-purpose, lithium-based grease. If
the machine is operated under normal conditions, lubricate all
bearings and bushings after every 50 hours of operation or
immediately after every washing.
The grease fitting locations and quantities are:
Traction Unit
Service Interval: Every 50 hours
•
Brake pedal pivot shaft bearings (2)
•
Front and rear axle pivot bushings (2)
•
Steering cylinder ball joints (2)
•
Tie rod ball joints (2)
•
King pin bushings (2)
The top fitting on the king pin should only be
lubricated annually (2 pumps).
Figure 35
Figure 36
(Figure 35)
(Figure 36)
(Figure 37)
(Figure 37)
(Figure 37).
Center Cutting Unit
Note: Deck may have to be raised to expose the grease
fittings for the latch pivot and the lower link.
Latch pivot (2) (Figure
Note: The latch
(Figure
to gain access to the grease fitting. Use a prybar to close and
re-open the latch
1. Latch
38
Figure 37
39)
38) may need to be manually tripped
Figure 38