Toro 07211 Operator's Manual page 30

Liquid cooled gas utility vehicle
Table of Contents

Advertisement

Coolant Temperature Gauge
Registers coolant temperature in engine. Operates only
when ignition switch is in On position (Fig. 23).
Engine Low Oil Pressure Light
Light glows (Fig. 23) if engine oil pressure drops below a
safe level while engine is running. If light flickers or
remains ON, stop vehicle, turn off engine and check oil
level. If oil level was low, but adding oil does not cause
light to go out when engine is restarted, turn engine off
immediately and contact your local TORO distributor for
assistance.
Important
Do not operate vehicle until repair is
complete. Failure to observe this precaution may result in
damage to the engine.
Ignition Switch
The ignition switch (Fig. 23), used to start and stop the
engine, has three positions: OFF, RUN and START. Rotate
key clockwise — START position — to engage starter
motor. Release key when engine starts. The key will move
automatically to the ON position. To shut engine off, rotate
key counterclockwise to OFF position.
Charge Indicator
Illuminates when battery is being discharged. If light
illuminates during operation, stop vehicle, turn off engine
and check for possible causes, such as alternator belt
(Fig. 23).
Important
If alternator belt is loose or broken, do not
operate vehicle until adjustment or repair is complete.
Failure to observe this precaution may result in damage to
the engine.
To check operation of warning lights:
• Apply parking brake.
• Turn ignition key to "ON", but do not start engine. The
charge indicator and oil pressure lights should glow. If
any light does not function, either a bulb is burned out
or there is a malfunction in the system which must be
repaired.
Note: Two functions of the warning light cluster are not
used: glow plug and high water temperature.
Hour Meter
Indicates the total hours of machine operation. The hour
meter (Fig. 24) starts to function whenever the key switch
is rotated to "ON" position.
Light Switch
Toggle switch (Fig. 24) to activate headlights. Push to turn
lights "ON".
Fuel Gauge
Shows amount of fuel in tank. Operates only when ignition
switch is in "ON" position (Fig. 24).
3rd High Lockout Switch
Moving switch (Fig. 24) to slow–
removing key will prevent use of third gear when in the
High range. Engine will shut off if shift lever is moved to
third gear when in High range. Key is installed with teeth
pointing downward. Push key in to turn. Key is removable
in either position.
3
2
4
1. Light switch
2. Hour meter
3. Fuel gauge
Steering Wheel
Turns vehicle. If engine stalls or power assist fails due to a
malfunction, vehicle steering will require greater effort
(Fig. 24).
30
– position and
5
1
Figure 24
4. 3rd high lockout switch
5. Steering wheel

Advertisement

Table of Contents
loading

This manual is also suitable for:

07211tc0721207218Workman 42003200

Table of Contents