Table of Contents
Advertisement
5
Click General tab and select a LAN driver from
Connect using:. Select Internet Protocol(TCP/IP)
and click Properties.
The displayed LAN driver may vary depending on the
LAN device type.
Click Install to add a network component as shown in
the figure below: You can add a client, a service, or a
protocol.
6
Configure IP settings.
Select Obtain an IP address automatically when
using DHCP. If you use a static IP, select Use the
following IP address and enter the values.
If the IP of your computer is not automatically assigned,
contact the network administrator.
7
If all settings are made, click OK. Now the network
configuration is finished.
71
Advertisement
Table of Contents
