Toro LT2240 Installation Instructions Manual page 7

3. Remove the boot from the seat base as follows
A. At the sides of the seat-base boot, locate its mounting tabs that protrude through the slot in the
channel of the seat base.
1. Tabs (seat-base boot)
B. Pull each tab along the slot until the tab is over the hole and then pull the tab out and away from
the seat-base channel.
Note:
Pull the boot forward or rearward depending on which tab you are the removing.
C. When all of the tabs are removed from their slots, pull the rubber boot up to gain access to the 4
bolts (8 x 25 mm) securing the seat to the platform
(Figure 9).
Figure 9
2. Slots (seat-base channel)
(Figure 10).
7
g037076
g037047