Toro LT2240 Installation Instructions Manual page 4

2
Removing the Existing Seat
Model 31654
No Parts Required
Procedure
Seat weight: 38 kg (84 lb)
Note:
Have another person help you remove the seat
or use a suitable crane.
1. Disconnect the connector for the seat-switch
wire harness from the connector of the machine
wire harness (Figure
2. Route the connector for the seat-switch wire
harness through the seat platform and secure
the connector to the seat.
5).
Figure 5
3. Remove the boot from the seat base as follows
(Figure 6).
A. At the sides of the seat-base boot, locate its
mounting tabs that protrude through the slot
in the channel of the seat base.
1. Tabs (seat-base boot)
B. Pull each tab along the slot until the tab is
over the hole and then pull the tab out and
away from the seat-base channel.
Note:
depending on which tab you are the
g036778
removing.
C. When all of the tabs are removed from their
slots, pull the rubber boot down
4
Figure 6
2. Slots (seat-base channel)
Pull the boot forward or rearward
g037076
g037047
(Figure 7).