Sealey AP1200MW Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
refer to
instruction
manual
1. SaFeTY
1.1. general SaFeTY
Warning! ensure Health & safety, local authority, and general workshop practice regulations are adhered to when using this trolley.
‰
Always load evenly with the centre of gravity of the load as near centre of the trolley as possible.
9
Do noT overload the trolley - see specifications - section 3.
8
use the trolley in a suitable work area.
9
Keep the work area clean, uncluttered and ensure there is adequate lighting.
9
Keep the trolley clean and tidy in accordance with good workshop practice.
9
Do noT use the trolley for any purpose other than that for which it is designed.
8
Do noT stand on the trolley, use it as a ladder or allow others to ride on the trolley.
8
use the wheel locks to prevent the trolley from inadvertently moving.
9
Do noT leave unattended, especially when loaded, unless the wheels are locked, chocked or the trolley otherwise secured.
8
Do noT use trolley on uneven ground and Do noT run over curbs or steps - use a ramp.
8
Do noT use trolley if any part is significantly damaged, paying particular attention to the wheels.
8
Keep children and unauthorised persons away from the work area.
9
2. inTroDucTion
i
industrial quality mobile engine repair workbench. sturdy steel construction with powder coating finish to prevent corrosion. Angled worktop to one
drain point makes this ideal for working on engines, transmissions, gearboxes or hydraulic systems. All fluids drain into a removable polyethylene
container. features a lockable drawer, a bottom shelf ideal for parts and tool storage and four swivel castors, two of which are locking.
3. SpeciFicaTion
i
model no.: AP1200mW
overall size: (W x d x H) .....................1205 x 640 x 880mm
Worktable size (W x d x H) ..................... 1195 x 635 x 10mm
large drawer (x1) (W x d x H) ................340 x 430 x 130mm
shelf size (W x d x H) ............................ 1110 x 460 x 30mm
capacity ..................................................................... 250 kg.
4. conTenTS
f) 2 swivel locking wheels
© Jack sealey limited
instructions for
Mobile engine repair bench
model no:
A) 1 top
c) 1 Plastic box
G) 2 swivel wheels
i) 8 screws
m8 x 55
Original Language Version
ap1200MW
B) 1 shelf
d) 1 drawer
K) 16+1 screws
m6 x 12
J) 8 nuts m8
e) 4 legs
l) 16+1 nuts m6
m) 16+1 screws
m8 x 12
AP1200mW | issue 1 16/11/17