Mitsubishi Electric HS-U449 Service Manual page 36

(Installation)
Note : Install the LOADING ARM ASSY (TU) and
LOADING ARM ASSY (SP) in accordance with the
following procedure after installing the A/L LEVER.
1. Apply grease (MOLYKOTE G PASTE) [859D055O50]
to the specified parts on the MAIN PLATE ASSY in
Fig. 2-31-1.
2. Apply grease (MOLYKOTE G PASTE) [859D055O50]
to the specified parts on the A/L LEVER in Fig. 2-31-
2.
3. Install the A/L LEVER so that the mark on the A/L
LEVER faces to the flange of the LOADING ARM
ASSY (SP) as shown in Fig. 2-31-3.
Note : The part specified with oblique lines on the A/L
LEVER shall be positioned under the flange of the
LOADING ARM ASSY (SP).
4. Install the LOADING ARM ASSY (TU) so that the
marks on the LOADING ARM ASSY (TU) and the A/L
LEVER are aligned each other as shown in Fig. 2-31-
4.
5. Install the LOADING ARM ASSY (SP) so that the
mark on the LOADING ARM ASSY (SP) and the
reinforcement rib of the LOADING ARM ASSY (TU)
are aligned each other as shown in Fig. 2-31-4.
Note : Be sure to replace the removed LOADING ARM
ASSY (SP) with a new one.
Back
Apply grease (MOLYKOTE G PASTE)
to the parts marked by
A/L LEVER
LOADING ARM
ASSY (TU)
A/L LEVER
- 23 -
A/L LEVER
.
Fig. 2-31-2
Flange of
LOADING ARM ASSY (SP)
Boss
Part with
Mark
Oblique Lines
Fig. 2-31-3
LOADING ARM
ASSY (SP)
Reinforcement Rib
Mark
Mark
Fig. 2-31-4