Mitsubishi Electric HS-U449 Service Manual page 33

(Installation)
Note : Install the BRAKE BELT (TU) so that its felt side
touches the REEL DISK (TU side).
The grease applied to the BRAKE CAM PLATE and
the MAIN PLATE ASSY shall not adhere to the felt
side of the BRAKE BELT (SP).
1. Apply grease (MULTEMP AC-DM)[859D055O90] to
the specified parts on the MAIN PLATE ASSY in Fig.
2-27.
2. Install the REEL DISK (TU side).
3. Install the BRAKE BELT (TU) to the BRAKE (TU).
4. Install the BRAKE (TU).
5. Hook the BRAKE BELT (TU) to the REEL DISK (TU
side).
2-28.SHIFT LEVER
DECK POSITION : Normal
Remove the following parts before replacing the SHIFT
LEVER. Refer to the corresponding items to install them.
• STAY PLATE (Item 2-2)
• BOTTOM ASSY (Item 2-3)
• MOTOR HOLDER (Item 2-16)
• PINCH ARM CAP (Item 2-17)
• PINCH UNIT (Item 2-17)
• BRAKE CAM PLATE (Item 2-19)
• BRAKE (TU) (Item 2-27)
• REEL DISK (TU side) (Item 2-27)
(Removal)
1. Move the SHIFT SLIDER in Fig. 2-28 in the direction
shown by arrow A to release it from the SHIFT
LEVER.
2. Move the SHIFT LEVER in Fig. 2-28 in the direction
shown by arrow B to remove it.
(Installation)
1. Apply grease (MULTEMP AC-DM)[859D055O90] to
the specified parts on the new SHIFT LEVER in Fig.
2-28.
2. Apply grease (MULTEMP AC-DM)[859D055O90] to
the specified parts on the MAIN PLATE ASSY in Fig.
2-28.
3. Install the SHIFT LEVER so that Part (a) shown in
Fig. 2-28 is positioned under the MAIN PLATE ASSY.
4. Install the SHIFT SLIDER to the SHIFT LEVER.
SHIFT LEVER
a
B
A
SHIFT SLIDER
Apply grease (MULTEMP AC-DM)
to the parts marked by
- 20 -
Back
Back
Back
MAIN PLATE ASSY
.
Fig. 2-28