Mitsubishi Electric HS-U449 Service Manual page 34

2-29.CHARGE SPRING, SWING LEVER,
CHARGE ASSY
DECK POSITION : Normal
Remove the following parts before replacing the
CHARGE SPRING, SWING LEVER, and CHARGE
ASSY. Refer to the corresponding items to install them.
• STAY PLATE (Item 2-2)
• BOTTOM ASSY (Item 2-3)
• MOTOR HOLDER (Item 2-16)
• PINCH ARM CAP (Item 2-17)
• PINCH UNIT (Item 2-17)
• BRAKE CAM PLATE (Item 2-19)
(Removal)
1. Remove the CHARGE SPRING shown in Fig. 2-29
from the SWING LEVER.
2. Remove the SWING LEVER shown in Fig. 2-29.
3. Release Part a of the CHARGE ASSY shown in Fig.
2-29 from Part b of the MAIN PLATE ASSY to
remove the CHARGE ASSY.
(Installation)
1. Apply grease (MULTEMP AC-DM)[859D055O90] to
the specified parts on the MAIN PLATE ASSY in Fig.
2-29.
2. Install the CHARGE ASSY.
3. Install the SWING LEVER, inserting Part c of the
SWING LEVER in Fig. 2-29 into the groove in the
MAIN PLATE ASSY.
4. Install the CHARGE SPRING to the SWING LEVER.
2-30.SPACER PLATE, LOADING ARM
ASSY (SP), LOADING ARM ASSY (TU)
DECK POSITION : Upside down
(Removal)
1. Release the catch (a) of the LOADING ARM ASSY
(SP) shown in Fig. 2-30-1 to remove the LOADING
ARM ASSY (SP).
Note : Be sure to replace the removed LOADING ARM
ASSY (SP) with a new one.
2. Remove the screw (b) fastening the SPACER PLATE
shown in Fig. 2-30-1 to remove the SPACER PLATE.
3. Remove the LOADING ARM ASSY (TU) shown in Fig.
2-30-1.
CHARGE SPRING
c
SWING LEVER
Front
Back
Both Sides
(Front/Back)
REEL DISK (SP side)
MAIN PLATE ASSY
- 21 -
a
CHARGE ASSY
b
MAIN PLATE ASSY
Fig. 2-29
b
SPACER PLATE
LOADING
ARM ASSY (TU)
LOADING ARM
a
ASSY (SP)
GREASE (MULTEMP AC-DM)
Fig. 2-30-1