Mitsubishi Electric HS-U449 Service Manual page 25

2-16.FC HOLDER, MOTOR HOLDER,
LOADING WORM, LOADING MOTOR
ASSY, WORM WHEEL
DECK POSITION : Normal
(Removal)
1. Release the two catches (a) of the FC HOLDER
shown in Fig. 2-16-1 to remove the FC HOLDER.
2. Remove the two screws (b) fastening the MOTOR
HOLDER shown in Fig. 2-16-1 to remove the MOTOR
HOLDER.
3. Remove the two screws (c) fastening the LOADING
MOTOR ASSY shown in Fig. 2-16-1 to remove the
LOADING MOTOR ASSY and LOADING WORM.
4. Remove the WORM WHEEL.
(Installation)
1. Apply grease (MULTEMP AC-DM)[859D055O90] to
the LOADING WORM shown in Fig. 2-16-2.
2. Apply grease (MULTEMP AC-DM)[859D055O90] to
the WORM WHEEL shown in Fig. 2-16-2.
3. Install the WORM WHEEL.
4. Install the LOADING WORM and LOADING MOTOR
ASSY to the MOTOR HOLDER.
Note : Tighten the screw (c) shown in Fig. 2-16-1 after
putting the LUG TERMINAL on the screw.
5. Install the MOTOR HOLDER.
6. Install the FC HOLDER.
a
FC HOLDER
c
LUG TERMINAL
WORM WHEEL
WORM WHEEL
Apply grease (MULTEMP AC-DM)
to the parts marked by
- 12 -
LOADING MOTOR ASSY
b
b
a
LOADING
WORM
MOTOR
HOLDER
Fig. 2-16-1
LOADING WORM
.
Fig. 2-16-2