Huawei CX600-8 Hardware Description page 76

HUAWEI CX600-8/16/X3/X8/X16 Metro Service Platform
Hardware Description
Interface Name
CTL-ETH-SFP interface
(1000MBase-X)
MGMT-ETH interface
(10M/100M/1000M
Base-TX auto-sensing)
Console interface
AUX interface
CLK/TOD0
CLK/TOD1
CLK/1PPS
CLK/Serial
Interface Attributes
Table 3-17
Table 3-17 1000MBase-X-SFP interface attributes
Attribute
Connector type
Operation mode
Standard compliance
Issue 03 (2013-11-30)
NOTE
BITS2 provides two SMB ports, and the signal type can be set to 2Mbps/2Mhz/1PPS+RS232. When signal
is 2Mbps/2Mhz, CLK/1PPS is fixed as input and CLK/Serial is fixed as output. When signal is 1PPS
+RS232, CLK/1PPS and CLK/Serial are bound together, CLK/1PPS signal type is 1PPS whereas CLK/
Serial signal type is RS232, and the setting of input/output apply to both SMB ports.
lists the 1000MBase-X-SFP interface attributes.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Connector Type Description
SFP It is not used and reserved for the use after
capacity expansion.
RJ45 It connects to the NMS workstation and has
LINK and ACT indicators.
RJ45 It connects to the console for on-site
configuration of the system.
RJ45 It connects to the Modem for remote
maintenance through dialing.
RJ45 Bits0: It is used to input or output 2 Mbit/s
clock signals, 2 MHz clock signals, 1pps
+ASCII clock signals, or two channels of
DCLS clock signals.
RJ45 Bits1: It is used to input or output 2 Mbit/s
clock signals, 2 MHz clock signals, 1pps
+ASCII clock signals, or two channels of
DCLS clock signals.
SMB Bits2: It is used to input or output 2 Mbit/s
clock signals, 2 MHz clock signals, or 1
PPS signals.
SMB Bits2: It is used to input or output 2 Mbit/s
clock signals, 2 MHz clock signals, or
RS232 signals.
Description
SFP
1000M fiber
IEEE 802.3-2002
3 CX600-X16
57