Huawei CX600-8 Hardware Description page 128

HUAWEI CX600-8/16/X3/X8/X16 Metro Service Platform
Hardware Description
Table 4-27 Interfaces on the SRU and their uses
Interface Name
USB interface
CF card interface
CTL-ETH-SFP interface
(1000MBase-X)
MGMT-ETH interface
(10M/100M/1000M
Base-TX auto-sensing)
Console interface
AUX interface
CLK/TOD0
CLK/TOD1
CLK/1PPS
CLK/Serial
Interface Attributes
Table 4-28
Issue 03 (2013-11-30)
NOTE
Bits2 includes 2 SMB ports, and the signal type can be set as 2Mbps/2Mhz/1PPS+RS232. When signal is
2Mbps/2Mhz, CLK/1PPS is fixed as input and CLK/Serial is fixed as output. When signal is 1PPS+RS232,
CLK/1PPS and CLK/Serial are bound together, CLK/1PPS signal type is 1PPS whereas CLK/Serial signal
type is RS232, and the input/output settings apply to both SMB ports.
lists the 1000MBase-X-SFP interface attributes.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Connector Description
Type
USB It is not used and reserved.
TYPE II It is used to hold a CF card to store data files as
a massive storage device.
(compatible
with TYPE I)
SFP It is not used and reserved for future capacity
expansion.
RJ45 It connects to the NMS workstation and has
LINK and ACT indicators.
RJ45 It connects to the console for on-site
configuration of the system.
RJ45 It connects to the Modem for remote
maintenance through dialing.
RJ45 Bits0: It is used to input or output 2 Mbit/s clock
signals, 2 MHz clock signals, 1pps+ASCII clock
signals, or 2-channel DCLS clock signals.
RJ45 Bits1: It is used to input or output 2 Mbit/s clock
signals, 2 MHz clock signals, 1pps+ASCII clock
signals, or 2-channel DCLS clock signals.
SMB Bits2: It is used to input or output 2 Mbit/s clock
signals, 2 MHz clock signals, or 1 PPS signals.
SMB Bits2: It is used to input or output 2 Mbit/s clock
signals, 2 MHz clock signals, or RS232 signals.
4 CX600-X8
109