Huawei CX600-8 Hardware Description page 115

HUAWEI CX600-8/16/X3/X8/X16 Metro Service Platform
Hardware Description
Figure 4-18 Appearance of the SFUI-100-D
Panel
Figure 4-19
Figure 4-19 Appearance of the panel
1. Ejector lever
5. RUN indicator
Table 4-13
Table 4-13 Buttons and indicators on the panel of the SFUI-100-D
LED
RUN
ACT
OFFLINE
The SFUI-100-D can be used only on the CX600-X8.
The 100G switch fabric unit can be used only together with the 100G Switch and Route Processing Unit A7.
The 100G switch fabric unit cannot be used together with 40G switch fabric unit and 200G switch fabric unit
for long-term working, and can be used together only for short-term operation during upgrade.
Issue 03 (2013-11-30)
shows the appearance of the panel.
2. ACT indicator
describes the buttons and indicators on the panel of the SFU.
Description
Before the registration of the SFU: If the green indicator blinks twice each
second (2 Hz), the system is in the alarm state.
After the registration of the SFU: If the green indicator blinks once every two
seconds (0.5 Hz), the system is running normally.
If the green indicator is on, it indicates that the SFU is working normally; if the
green indicator is off, it indicates that the SFU is faulty.
When the SFU is working normally, the OFL indicator is off. After the OFL
button is pressed to power off the SFU, the OFL indicator is on.
NOTE
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3. OFL button 4. OFL indicator
4 CX600-X8
96