Samsung QND-6010R User Manual page 54

setup screen
4. Click the [create] button.
5. After entering the shared folder name(ID), click the [oK]
button to create a shared folder.
In this example, the shared folder name is [testDirectory].
6. In Windows, for NAS access, set the privilege for the shared
folder as follows.
Check the admin's [read/write].
7. Click on the <user> in the file sharing and privilege menu.
8. After clicking the [create] button, enter name(ID) and
password.
In this example, name(ID) is set to [testiD] and password is
also set to [testiD].
According to the NAS recommendations, when you use Netgear's
`
J
NAS equipment, do not allocate the capacity for use.
9. In Windows, set the privilege for NAS access.
For the shared folder created in step 4 called "testDirectory"
check [read/write].
54_ setup screen
10. Basic setting in the NAS is completed.
Connect your camera to the actual NAS.
As shown below, enter the NAS connection setting items.
11. After entering item 10, check <on>.
12. Click the [apply ( )] button.
Finish saving by using the NAS.
alarm output
1. From the Setup menu, select the <event (
2. Click <alarm output>.
3. Configure the camera alarm output settings.
If you change the alarm output type, the alarm out button on the
`
monitoring page and alarm output type displayed on Event Setup page
will be changed accordingly.
• Type
- Normal open : Considers "Open circuit" status of the
sensor or alarm input device as normal, and triggers alarm event if becomes "Closed circuit" status.
- Normal close : Considers "Closed circuit" status of the sensor or alarm input device as normal, and
triggers alarm event if becomes "Open circuit" status.
• Mode : Sets the alarm output method.
There is difference between operations when clicked alarm output button while disabled.
`
- Pulse : It is activated during the time period specified by the duration (switching interval) and then
becomes inactive automatically.
- Active/Inactive : It maintains as activated until the user clicks the button again to make it inactive.
• Duration : Set the alarm duration that maintains activated if the mode is set to pulse, from 1 to 15
seconds.
4. When done, click [apply ( )].
)> tab.