Samsung QND-6010R User Manual page 50

setup screen
802.1x
When connecting network, you can choose whether using 802.1x protocol, and then install the certification.
1. From the Setup menu, select the <network (
2. Click <802.1x>.
3. Set the <ieee 802.1x setting>.
• IEEE 802.1x : Specify the use of the 802.1x protocol.
• EAP type : Select EAP-TLS or LEAP.
• EAPOL version : Select version 1 or 2.
• ID : Enter the client certificate ID in EAP-TLS and the user
ID in LEAP.
• Password : Enter the client private key password in EAP-
TLS and the user password in LEAP. You do not have to
enter the password in EAP-TLS if it uses a key file that is not encrypted.
If the connected network device does not support the 802.1x protocol, the protocol will not operate properly even if you set it.
`
J
LEAP is an authentication method with poor security. Use it only in an environment where EAP-TLS is not available.
`
4. Install/remove the certificate.
The certificate is needed only for EAP-TLS.
• CA certificates : Select a public certificate that contains the public key.
• Client certificate : Select a public certificate that contains the client certificate key.
• Client private Key : Select a public certificate that contains the client private key.
5. When done, click [apply ( )].
to install/remove 802.1x related certificates
1. Press the [Browse ( )] button for each item and select a certificate to install.
2. If no certificate is installed, you will see "Not Available" appearing next to the selected item.
3. Press the [install ( )] button to start installation with a message of "Installed" next to the item.
4. Press the [Delete ( )] button to remove the certificate.
50_ setup screen
)> tab.
QoS
You can specify the priority to secure a stable transfer rate for a specific IP.
1. From the Setup menu, select the <network (
2. Click <QoS>.
3. Click the [add ( )] button.
The IP list will be created.
4. Enter an IP address to which you will apply QoS.
The default prefix for IPv4 is 32;
`
M
For DSCP, the default is set to 63.
Only the IP addresses that are set to <Use> can be prioritized.
`
5. Select an IP to delete from the list.
Click the [Delete ( )] button.
6. When done, click [apply ( )].
Snmp
With the SNMP protocols, the system or network admin can monitor the network devices on a remote site,
and configure the environment settings.
1. From the Setup menu, select the <network (
2. Click <Snmp>.
3. Specify the <Snmp>.
• Enable SNMP v1 : SNMP version 1 will be active.
• Enable SNMP v2c : SNMP version 2 will be active.
- Read community : Provide the name of the read
community where you can access to the SNMP
information.
The default name is <public>.
- Write community : Provide the name of the write
community where you can access to the SNMP information. The default name is <write>.
• Enable SNMP v3 : SNMP version 3 will be active.
- Password : Specify the default password for SNMP version 3.
The default password can be exposed to a hacking thread so it is recommended to change the password after installing the
`
product.
Note that the security and other related issues caused by the unchanged password shall be responsible for the user.
Password should be longer than 8 characters, no more than 16 characters.
`
)> tab.
)> tab.