Samsung QND-6010R User Manual page 46

setup screen
to Set exposure
You can adjust the exposure level of the camera.
1. Select <exposure>.
2. Select each item and set it properly.
• Brightness : Adjust the screen brightness.
• Minimum shutter : The limit of the longest exposure time.
Shutter is the mode to set up the range of the sensor exposure time
`
which will specify the upper and lower limits for the electronic shutter
movement.
The framerate may be reduced in the dark condition if Shutter has a
`
lower value than specified in the Sensor mode.
• Maximum shutter : The limit of the shortest exposure time.
• Anti flicker : It prevents screen flickering incurring from the dissonance between the surrounding lighting
and the frequency.
• SSNR : Noise of the video is removed.
• SSNR level : Adjust the noise reduction level.
• AGC : Select AGC Control mode.
Adjust the gain value of the video (that, in particular, was recorded at a low contrast scene and had a
lower brightness level than normal) to control the video brightness.
The image exposure can be saturated depending on the Shutter setup range.
`
J
46_ setup screen
to Set Day/night
1. Select <Day/night>.
2. Select each item and set it properly.
• Mode : Mode is used to adjust the color of Color or Black
and White.
- Color : The video is always output in color.
- B/W : The video is always output in black and white.
- Auto : Normally, it is set to Color but to B&W under low
luminance at night.
If AGC of the <Exposure> menu is set to <Off>, the day/night
`
mode cannot be set to <Auto>.
- External : It controls the color of the video when the
alarm input terminal is synchronized with an external
device.
- Schedule : Set the time during which the camera is
operated in the color mode.
• Dwell Time : It specifies the period for which the selected brightness condition must be maintained to
switch the lighting mode from Day to Night or vice versa.
• Duration : It specifies the interval of lighting mode conversion.
• Alarm in : The video is set to Color or B/W as the alarm sensor is open or closed.
If the Day/Night mode is set to External Input, the alarm input function of the Event-Alarm Input page is disabled.
`
• Activation time(Color) : It specifies the schedule for color mode operation.
If it is set, the Color mode is maintained from 00 second of the starting time to 59 second of the ending time.
`
When switching to the day/night mode, the motion detection mode does not work.
`
J