Samsung SCP-3371/SCP-3371H User Manual page 6

CAUTION
These servicing instructions are for use by qualifi ed service personnel only. To reduce the risk of electric
shock, do not perform any servicing other than that contained in the operating instructions unless you are
qualifi ed to do so.
DETAILED WARNINGS AND CAUTIONS
Avoid operating the camera for long durations under high temperatures and in high humidity. Excessive
heat can shorten the lifespan of the camera components.
Do not install or place the camera near any heat sources.
Subjecting the dome cover to physical shock may damage the camera and cause water leakage into it.
Do not place the camera facing direct sunlight or other intense light sources. Strong lights such as
spotlights can cause distortions—blooming and smear—as well as discolorations on the screen by
heating up the color fi lter of the camera. They also may cause internal refl ections of the camera, leading
to operational malfunctions.
Do not drop the camera or subject it to physical shock or vibration; this can cause serious damage to the
camera.
When installing the camera near a power line, make sure to keep at least 1 meter distance from the
power line, or earth an additional metal pipe to separate the camera from the power source.
Install this camera on the ceiling. Installing it on the ground or a unleveled location may cause product
malfunctions and shorten its lifespan.
Avoid installing and operating the camera in the following places.
- Places whose temperature exceed the camera's recommended range.
(Indoor : -10º ~ 55º, Environmental : -50º ~ 55º)
- Places where drastic temperature changes occur: e.g. Near an air conditioner.
- Places that are exposed to steam, oil, and infl ammable substances: e.g. Inside a kitchen.
- Places that are exposed to radioactivity, X-rays, strong electric waves, and electro-magnetic waves.
- Places that are exposed to outdoor air contaminants: e.g. Dust and car exhaust.
- Places in high humidity.
- Places that are exposed to corrosive gas: e.g. Next to the sea.
Smeared and dusty dome covers decrease the picture and video quality. Clean the dome cover and
camera lens on a regular basis.
Remove the plastic wrap on the dome cover only after the camera installation is complete.
This camera is not equipped with a power switch. Plug in the camera only after the installation is
complete.
6_ important safety instructions