Electrical Installation; Electrical Connection - ABB ACS560 Quick Installation And Start-Up Manual

Electrical installation

Refer to Electrical installation
wiring accordingly. The BIO-01 module has removable spring clamp terminals. Use
ferrules on the multistranded cables before assembly.
￭ BIO-01 Electrical connection
Sample wiring with the ABB standard macro:
Terminals
External sample connection
Start-up
￭ Install BIO-01
The BIO-01 module is automatically identified by the drive firmware. To configure the
By default, RIIO-01 module is provided in ACS560 standard R0...R2 drives. You can remove
inputs refer to the ACS480 firmware manual
the RIIO-01 module and can install BIO-01 and/or fieldbus adapter module (+Fxxx).
To install BIO-01 or/and fieldbus module, perform the following steps
1. Remove the front cover(s). See chapter Electrical installation in the hardware manual.
2. Remove the existing RIIO-01 module. To remove,
Note: The RIIO-01 module is available by default in standard ACS560-01 R0...R2 drives.
a. Loosen the locking screw.
b. Pull the locking tab out and unlock the RIIO-01 module.
on page 55. If you configure the inputs, set up the EN - Quick installation and start-up guide 27
Description
Aux. voltage output and prog. digital input
+24V Aux. output +24 V DC, max. 200 mA
DGND Aux. voltage output common
DCOM Digital input common for all
DI1 Stop (0)/Start (1)
DI2 Forward (0)/Reverse (1)
Digital and analog I/O extension BIO-01
DI3 Constant frequency/speed selection
DI4 Constant frequency/speed selection
DI5 Ramp set 1 (0)/Ramp set 2 (1)
DO1 Not configured
AI1 Output frequency/speed ref: 0...10 V
+10V Ref. voltage +10 V DC (max. 10 mA)
GND Analog circuit common / DO common
SCR Signal cable shield / DO screen
Safe torque off (STO)
SGND Safe torque off. Factory connection.
Both circuits must be closed for the
IN1
drive to start.
IN2
OUT1
(3AXD50000047399 [English])
Base Internal connection
unit
X
X
X
X
X
X
X
X
X
.
EN
HI