ABB ACS560 Quick Installation And Start-Up Manual page 19

￭ Connection procedure, frames R5...R8
86 Electrical installation
If the drive will be connected on an IT (ungrounded) system, make sure you have
86 Electrical installation
disconnected the EMC filter and Varistor (VAR). See
Connection procedure, frames R6...R8
Connection procedure, frames R6...R8
1. Attach the residual voltage warning sticker next to the control board.
2. Remove the side plates of the cable box as follows:
WARNING! If the drive will be connected on an IT (ungrounded) system,
WARNING! If the drive will be connected on an IT (ungrounded) system,
make sure you have disconnected the EMC filter and ground-to-phase varistor.
• Remove the retaining screws.
make sure you have disconnected the EMC filter and ground-to-phase varistor.
See page 71. If the drive will be connected on a corner-grounded TN system, make
• Slide the walls out.
See page 71. If the drive will be connected on a corner-grounded TN system, make
sure you have disconnected the EMC filter. See page 71.
sure you have disconnected the EMC filter. See page 71.
1. Attach the residual voltage warning sticker next to the control board.
1. Attach the residual voltage warning sticker next to the control board.
2. Remove the side plates of the cable box as follows:
1
2. Remove the side plates of the cable box as follows:
• Remove the retaining screws.
• Remove the retaining screws.
• Slide the walls out.
• Slide the walls out.
1
1
3. Remove the shroud on the power cable terminals by releasing the clips with a
3. Remove the shroud on the power cable terminals by releasing the clips with a screwdriver
3. Remove the shroud on the power cable terminals by releasing the clips with a
screwdriver and pulling the shroud out.
and pulling the shroud out.
screwdriver and pulling the shroud out.
4. Knock out holes in the shroud for the cables to be installed.
4. Knock out holes in the shroud for the cables to be installed.
4. Knock out holes in the shroud for the cables to be installed.
5. Frames R8: If you install parallel cables, also knock out holes in the lower shroud
5. Frame R8 only: If you install parallel cables, also knock out holes in the lower shroud
5. Frames R8: If you install parallel cables, also knock out holes in the lower shroud
for the cables to be installed.
for the cables to be installed.
for the cables to be installed.
3
3
3
3
Motor cable
6. Cut an adequate hole into the rubber grommet. Slide the grommet onto the cable.
EN - Quick installation and start-up guide 19
2
2
2
4
4
4
EMC filter (page 29).
R8...R8
Frame R8
R8...R8
5
5
EN
HI