Table of Contents
Advertisement
5.
Lift the cab frame using the lift points and place
it on the machine
Figure 11
1. Lift points
6.
Secure the sides of the cab frame to the machine
using 6 hex-head bolts (3/8 x 1-1/4 inches), 6
washers (3/8 inch), and 6 flange nuts (3/8 inch)
as shown in
Figure
Note:
Torque the hex-head bolts (3/8 x 1-1/4
inches) to 58 N∙m (43 ft-lb).
Figure 12
1. Hex-head bolt (3/8 x 1-1/4
inches)
2. Washer (3/8 inch)
(Figure
11).
12.
3. Flange nut (3/8 inch)
7.
Secure the back of the cab frame to the left and
right supports using 4 flange-head bolts (5/16 x
1-1/4 inches), 2 support plates, 4 flat washers,
and 4 flange nuts (5/16 inch) as shown in
13.
Note:
Torque the bolts to 34 N∙m (25 ft-lb).
g037103
1. Flange-head bolt (5/16 x
1-1/4 inches)
2. Support plate
8.
Tighten the left and right supports, and torque
the bolts to 58 N∙m (43 ft-lb) as shown in
7.
9.
Install the previously removed left handhold
using the 3 screws and 3 nuts
10.
Install the upper, rear foam seal
g037137
1. Upper, rear foam seal
10
Figure 13
3. Flat washer
4. Flange nut (5/16 inch)
(Figure
9).
(Figure
Figure 14
Figure
g035253
Figure
14).
g038338
Advertisement
Table of Contents
