The floor must have a sufficient load
bearing capacity! If, for example, you
are stacking a washer and the dryer, this
combination can– when loaded– reach
a total weight of 160 kg.
Important:
• Place appliance on an even and level floor
only.
• Do not place appliance on the power
cable.
• Keep at least 1 cm distance to walls or
other furniture.
Washer/dryer combination
This appliance can be put on top of any of
our washing machines.
• A special stacking kit is required (stock
no.2955600100), available at the
customer service or specialized dealer.
Leveling
•
Adjust feet until the appliance is
leveled and does not rock. Checking with a
spirit level is recommended.
Important:
•Adjust by the feet only, do not use wooden
wedges or similar. Never remove the feet!
Changing hinge position
If you wish to open the door to the other
side, you can have the hinge position changed
from left hand to the right and or vice versa
by our customer service.
Connecting the drain hose
The water (condense water) accumulated
during the drying process is caught in the
water tank, which you have to empty after
every drying.
You can drain the water continuously through
the included drain hose by connecting it to
a spout or other water drainage.
In this case you don't need to empty the
water tank after every drying cycle. The
indicator "Empty water tank" will flash anyway
at the end of every program. .
Important Advice
The length of the hose and the highest point
over the floor have to be taken into
consideration for the draining of the water.
Install the hose without kinks!
Install as follows:
1 . At the water drainage connecting pull up
the condensate hose out of the appliance
by hand. Don't use pliers!
2. Connect the drain hose securely to the
water drainage connection.
3. Lay and connect the drain hose to the
drainage
4. Secure the drain hose against slipping
when hang it over the sink or tub.