Table of Contents
Advertisement
2-9 Deck Pulley Installation Cont...
Figure 2-9a
Remove the bolt and hardware from the existing pulley
and place the pulley assembly P#(A1057) on top of the
existing deck pulley. Fasten both pulleys to the deck
using the existing hardware removed from the original
deck pulley. Figure 2-9b.
Figure 2-9b
2-10 Deck Drive Assembly Installation
!
WARNING
Stop unit, shut off deck attachment, set parking
brake, shut off mower engine and remove spark plug
wire before installing PTO Deck Drive Assembly.
Do not work around the mower deck, PTO deck drive
or the blower area until you are certain that the
mower blades and the blower impeller have stopped
rotating.
Pulley Assembly
Existing Pulley Assembly
The deck drive assembly P#(A1055) will mount to the
flanges on the discharge side of the mower deck where
the grass deflector was removed in Section 2-9. The
mounting brackets on the deck drive assembly slide
down onto the existing brackets that held the grass
deflector on the mower deck. The deck drive assembly is
secured with (1) mount rod P#(B8168) which is placed
through the holes in the deck brackets and the holes in
the deck drive assembly bracket. Secure rod with (2)
hair pin clips P#(K0099). There is a hole in each end of
the mount rod. Place one hair pin clip in each hole. This
holds the deck drive assembly in place. Figures 2-10a
thru 2-10c.
Figure 2-10a
Figure 2-10b
9
Grass Deflector Brackets
Deck Drive Assembly
Advertisement
Table of Contents
