Table of Contents
Advertisement
2-12 Pulley Guard Installation Cont...
Figure 2-12d
Pulley Guard Clamp
Figure 2-12e
Mower Deck U-bolt
Secure pulley guard clamp with (1) 5/16"-18 star knob
P#(J0256). Figure 2-12f and 2-12g.
Figure 2-12f
Pulley Guard Clamp
5/16"-18 Star Knob
Figure 2-11g
2-13 Inlet and Hose Installation
With the top assembly P#(A0551) in the upright position,
insert the inlet P#(V1054) into the right hand hole in the
top assembly as shown in Figure 2-13a. Continue to
insert the inlet until it snap locks into place. The inlet
should now pivot freely about the hole.
Slide (1) upper hose clamp P#(J1000) onto both ends of
the 7" hose. Slide one end of the 7" hose onto the inlet.
Make sure there is about a two-inch overlap between the
hose end and the container inlet. Proceed to slide the
opposite end of the 7" hose onto the outlet of the PTO
deck drive assembly and tighten hose clamp. See
Figure 2-13a and 2-13b for details. Make sure both ends
of the hose are clearly attached to the inlet and the outlet
of the deck drive drive assembly. Tighten the hose
clamps.
Figure 2-13a
Inlet
Figure 2-13b
12
Installed Pulley Guard
Snap Inlet Into
Place Here
PTO Outlet w/ Hose and Clamp
Advertisement
Table of Contents
